Ring die granulators are high-value equipment in organic fertilizer production lines. Routine maintenance not only extends their service life but also reduces downtime, indirectly increasing production capacity.
First, ensure precise maintenance of the ring die and roller. After each production run, clean any remaining raw material from the die hole to prevent it from hardening and caking the die during the next run. Check the gap between the roller and the die weekly. If the gap exceeds 0.5mm, adjust it promptly to prevent insufficient extrusion and loose pellets. Check the ring die surface monthly for wear. If cracks appear along the die hole edge, repair or replace them promptly to prevent degradation of pellet appearance.
Second, ensure maintenance of the transmission system and lubrication. The gearbox and bearings are the core of the transmission. Check the gearbox oil level monthly. If the oil level is below the mark, add special gear oil to prevent gear wear. Fill the roller bearings with high-temperature resistant grease every two weeks to prevent overheating and damage from lack of oil. Be careful not to over-lubricate, as this will result in poor heat dissipation.
The third aspect is raw material pretreatment control: The core of maintenance is prevention. Before raw materials enter the ring die granulator, they must be screened to remove impurities to prevent hard impurities from scratching the ring die and rollers. At the same time, the raw material moisture content (18%-22%) and particle size (≤1mm after crushing) are strictly controlled to minimize equipment overload and component wear caused by unsuitable raw materials, thus reducing maintenance costs from the source.
